Light Kit Assembly - Craftmade FRESCO FRS52-LED Guia De Instalacion

9. Light Kit Assembly.

Remove 1 screw from motor plate on
underside of motor housing and partially
loosen the other 2 screws. Align slotted holes
in fitter plate with loosened screws in motor
plate, allowing molex connections from
motor housing to come through hole in
middle of fitter plate--remove and discard
plastic that holds these 2 wires together. Twist
fitter plate to lock. Re-insert screw that was
just removed and securely tighten all 3
screws with Phillips screwdriver.
Connect WHITE wire from motor housing to
WHITE wire from LED light kit. Connect
BLACK (or BLUE) wire from motor housing to
BLACK wire from LED light kit. [NOTE: It may
be necessary to push back sleeve on wires to
be certain of wire colors.] Be sure molex
connections snap together securely.
Remove 1 screw from underside of fitter plate
and partially loosen the other 2 screws.
Carefully arrange wiring within fitter plate.
Align slotted holes in LED light kit with
loosened screws in fitter plate. Twist LED light
kit to lock. Re-insert screw that was
previously removed and tighten all 3 screws
securely.
Align grooves on shade with nodules on
inside of LED light kit. Turn shade to the
RIGHT (clockwise) until it no longer turns.
NOTE: Pull down VERY GENTLY on shade to
make sure that shade is secured completely.
fitter plate
fitter plate
molex
connections
LED light kit
page 9
motor
housing
motor plate
molex
connections
motor
housing
nodule
groove
shade