DBI SALA Nano-Lok 3101423 Instrucciones Para El Usuario página 12

Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
6.0 MAINTENANCE, SERVICING, AND STORAGE
6.1 CLEANING: Cleaning procedures for the Nano-Lok SRL are as follows:
• Periodically clean the exterior of the SRL using water and a mild soap solution. Position the SRL so excess water can
drain out. Clean labels as required.
• Clean the Web Lifeline with water and mild soap solution. Rinse and thoroughly air dry. Do not force dry with heat.
The lifeline should be dry before allowing it to retract into the housing. An excessive buildup of dirt, paint, etc. may
prevent the lifeline from fully retracting back into the housing causing a potential free fall hazard.
IMPORTANT:
If the lifeline contacts acids or other caustic chemicals, remove the SRL from service and wash with
water and a mild soap solution. Inspect the SRL per Table 1 before returning to service.
6.2 SERVICE: Nano-Lok SRLs are not repairable. If the SRL has been subjected to fall force or inspection reveals an unsafe
or defective condition, remove the SRL from service and discard (see "Section 5.5 - Disposal").
6.3 STORAGE: Store Nano-Lok SRLs in a cool, dry, clean environment out of direct sunlight. Avoid areas where chemical
vapors may exist. Thoroughly inspect the SRL after any period of extended storage.
7.0 SPECIFICATIONS
7.1 PERFORMANCE: Your Nano-Lok SRL has been tested and certifi ed to the performance requirements of the standard(s)
identifi ed on the cover of this instruction manual. See "Section 2.0 - Limitations & Requirements" for performance
specifi cations.
7.2 MATERIALS: Material specifi cations for the Nano-Lok SRL are as follows:
Housing:
Drum:
Fasteners:
Locking Pawls:
Main Shaft:
End Connectors:
Motor Spring:
Swivel:
Lifeline
Tie-Back Portion
of Life Line
Load Indicator
7.3 DIMENSIONS: Figure 15 lists Nano-Lok SRL dimensions. Average length for the Nano-Lok SRL is 2.7 m (9 ft), but will
vary slightly with length differences in the various End Connector options (1 and 2). Retracted (3) and Extended (4)
length values in Figure 15 are approximations based on the total length of the fully retracted/extended SRL and the
applicable End Connectors.
7.4 LABELING: Figure 16 illustrates Nano-Lok SRL labeling. A: Identifi cation Label B: Use and Warning Label (see "Label
Image Identifi cation" ). All labels on the SRL must be present and fully legible.
Nylon, UV Resistant
Nylon, Type 6/6
Zinc Plated Steel Screws; Stainless Steel Rivets
Stainless Steel
Stainless Steel
See Figure 15 for End Connector options and their respective material specifi cations.
Stainless Steel
Zinc Plated Steel
Yellow Dynema Polyester Web,
25/32" Wide x .052" Thick
Blue Nylon Web, 1 3/16 x .120
Cover: Denier Textured blue Web Nylon, 1 3/16 x 0.120 in
Stitching: Polyester or Nylon Thread
Web: Polyester
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
12