Operation; Starting Up - Scheppach AB1900 Traducción Del Manual De Instrucciones Original

• Check the machine before use for
damaged parts and determine whether
these parts work properly and perform
its intended function; in case of doubt,
the part is to be replaced.
• Check the alignment of all moving parts,
broken or mounting parts, and other
conditions that could impair proper op-
eration. Any damaged part should be
repaired or replaced by a qualified tech-
nician.
• Do not use the machine if a switch can-
not be switched on and off correctly.
Caution! Before beginning the operation,
check the installation site for concealed
electrical cables, gas and water pipes us-
ing a pipe locator..

8. Operation

• Use only proper equipment.
• Make all machine adjustments only with
the machine switched off.
• Never leave the machine unattended
while it is running.
• When switching off, leave the machine
only after it comes to a complete stand-
still.
• Turn the machine off before you unplug
it.
• Always unplug the mains cord. Never
pull out the plug from the wall outlet by
holding the cable.
• Perform maintenance and cleaning of
the device regularly.
28 | GB
 www.scheppach.com /  [email protected] /  +(49)-08223-4002-99 /  +(49)-08223-4002-58

9. Starting up

Using the chisel Fig. 2
1. Clean chisel always before inserting it
and lubricate the shaft slightly.
2. Pull out the locking bolts (8) up to the
end stop, turn by 180° and release.
3. Insert chisel into the tool holder (6) and
slide it up to the end stop.
4. Pull out the locking bolts (8) once again,
turn by 180° and release.
5. Check lock on the tool.
Remove chisel
Pull out the locking bolts (8) up to the end
stop, turn by 180° and release, and re-
move the chisel.
Additional handle Fig.3
For safety reasons, use the demolition
hammer only with the additional han-
dle!
1. The additional handle (5) provides you
safe grip while using the demolition
hammer.
2. The additional handle (5) can be rotat-
ed to any position.
3. Loosen the screw (9).
4. Turn the additional handle (5) to a con-
venient and safe working position and
tighten the screw (9) again.
Switching ON / OFF (Fig. 4)
Switching ON: Press the operating switch
(2).
Switching OFF: Release the operating
switch (2).
Continuous operation: Press operating
switch (2) and lock with locking switch (10).