Cleaning - Electrolux WT150 Instrucciones De Funcionamiento

During Washing
• Press button "6" to start the feed system, the
pumps and the automatic wash program. The
following message appears on display "4":
WASHING (EFF)
X XXX (XXX)
When the set time has elapsed, the pumps stop,
while the feed system continues working. When a
dish rack reaches the dishwasher inlet, the pumps start
up again. If a dish rack arrives near the limit switch
located at the end of the feed system, the following
message appears:
End limit
Remove carrier
• Remove the dish rack so that the wash may
continue.
• Press the STOP button "7"; the following message
appears:
STANDBY....
READY TO OPERATE
The motors will stop, washing stops, but the machine
will remain on standby and remain hot.
This is the most economical for short pauses in
dishwashing.
• Check the strainer baskets in the tanks, emptying
them when necessary. The tank water can also be
changed during a pause in dishwashing - raise the
drain tap to empty the tank -close the door and the
tank will be refilled.
The dishwashing pumps and final rinse will stop
automatically when there are no more racks in the
wash tank or final rinse tank.

Cleaning

Switch off electrical supply before cleaning.
N.B! The machine should not be cleaned with
high pressure jets of water.
The machine should be cleaned after use each day. Use
hot water and if necessary a neutral detergent and soft
brush or sponge. If another type of detergent is used,
follow the manufacturer's instructions carefully, and take
note of the recommended safety precautions.
N.B!
Do not use steel wool or abrasive cleaning material when
cleaning stainless steel surfaces. If using detergent con-
taining chlorine, rinse extremely thoroughly. Chlorine and
chloride compounds which come into contact with stain-
less steel can cause corrosion.
34
Interior cleaning
• Switch the "On/Off" (0) to the 0 position.
• Switch off the "Main power switch".
• Open the doors.
• Drain the water by pulling up the drain tap
wash tank.
• Remove the strainer baskets
and rinse thoroughly.
• Remove the rinse arms
any blocked nozzles. If necessary remove the end
caps from the rinse pipe and rinse out.
• Fold-up or lift out the side plates
to allow the tank bottom to be cleaned.
• Rinse out the inside of the tanks.
• Remove the curtains
• Remove the fine strainer
the final rinse tank (F) and clean carefully.
Note. Take great care when cleaning the fine strainer.
• Clean the final rinse tank.
** = reg.condenser/ESD I- and J
Curtains
Curtains must be replaced when worn (not covered by
warranty)
Exterior cleaning
• Clean the exterior stainless steel surfaces of the equip-
ment with hot water, if necessary combined with a
neutral detergent and a soft brush or sponge.
• Panels and knobs should be drieed with a soft cloth.
Weekly cleaning
• Clean the inside of the doors by rinsing with a hose
through the loading or unloading zones or through the
door on the adjacent tank.
• Remove the final rinse arms on the DUO-rinse (the
arm closest to the power wash zone) in the final rinse
zone and clean carefully.
When the equipment is not in use
Carefully follow the instructions below if the
equipment will not be in use for any length of time.
• Switch off the dishwasher
• Switch off at the Mains Switch.
• Clean the machine internally and externally. Also
clean the parts that can be removed. See "Cleaning"
**
H
in the
, strainer plates
, rinse carefully and clean
- 2 in each tank -
, **, for cleaning.
and overflow from