To Stop The Product; General Work Instructions - Husqvarna 553RBX Instrucciones De Operación

3. Push the air purge bulb until the bulb starts to fill with
fuel.
4. Hold the body of the product on the ground with your
left hand. Do not put your feet on the product.
5. Pull the starter rope handle slowly until you feel
some resistance, then pull the starter rope handle
with force.
WARNING: Do not wind the starter rope
around your hand.
6. Continue to pull the starter rope handle until the
engine starts.
CAUTION: Do not pull the starter rope
until it stops. Do not let go of the starter
rope when it is fully extended. Release
the starter rope slowly. Risk of damage
to the product.
7. When the engine starts, put the choke control in the
run position and apply full throttle. The throttle trigger
automatically disengages from the start position.
8. Make sure that the engine runs smoothly.
WARNING: Keep body parts away from the
spark plug cap to prevent burn injuries. Risk
of burn injuries. Do not use the product with
a damaged spark plug cap. Risk of electrical
shock.
18

To stop the product

• Move the stop switch to the stop position to stop the
engine.

General work instructions

WARNING: Be careful when you cut a tree
that is in tension. It can spring back to its
normal position before or after the cut and
hit you or the product, and cause injury.
• Clear an open space at one end of the work area,
and start the work from there.
• Move in a regular pattern across the work area.
• Move the product fully to the left and right, to clear a
width of 4–5 m on each turn.
• Clear a length of 75 m before you turn and go back.
Move the fuel can along with you as you continue.
• Move in a direction where you do not go across
ditches and obstacles more than necessary.
1104 - 001 - 11.04.2019