Pellet Stove Installation; General Information - Bauhaus Tossi 8 Instrucciones Para La Instalación, Uso Y Mantenimiento

4. Pellet Stove installation

All NATIONAL AND LOCAL REGULATIONS AND EUROPEAN
STANDARDS SHALL BE COMPLIED WITH WHEN
INSTALLING THE APPLIANCE
Before install a stove in a room, select the right stove to be able to
heat the room. Please check the STOVES' Heating area in the
Chapter of STOVE FEATURE.
COMPLETE THE STOVE BEFORE INSTALLATION

GENERAL INFORMATION

The stove must be connected to a chimney that is approved for solid fuels. The chimney must
have a diameter of at least 80 mm.
The flue system is based on negative pressure in the combustion chamber and a slight
overpressure on the flue gas outlet. It is therefore important that the flue gas connection is
fitted correctly and is airtight.
Only use heat resistant sealing materials, as well as the relevant sealing bands,
heat resistant silicon and mineral wool.
Only authorised technical personnel must carry out assembly work.
In addition you must ensure that the flue tube does not project into the free cross section of
the chimney.
NOTE: Please follow the regionally valid building regulations. Contact your master
chimney sweep for information on this.
Ensure that outlet routes to the chimney are not too long.
Avoid too many changes of direction for the flue gas flow to the chimney. (e.g. too many
corners and bends).
Where you cannot connect directly to the chimney, if possible use a connection piece with
8