Bauhaus Tossi 8 Instrucciones Para La Instalación, Uso Y Mantenimiento página 101

HOWEVER, It is possible to switch off the heater in every functioning phase. The switching off performs
pressing the key ON/OFF
"Stabilisation", After push the button, then the phrase "Cooling" comes
After the stove's temperature falling down, the stove starts again, Cleaning-feeding-lighting-stabilization.
-------------------------------------------------------------------------------------------------------------------
How to make the stove immediately skip the process to Stabilization During the first several stages when you
think the flame is ok and/or the stove can work properly?
Push for 3 seconds, and then it will turn on Stabilizationdirectly.
If the heater is switched off, the flame will continue to be present up to the fuel exhaustion contained in the
melting pot, this phase will manage in automatic way both fans and it will have the duration up to 5-8
minutes.
The switching off phase is displayed from the message 'SWITCHING OFF" present up to the
end of the operation.
Whether the heater is switched or not, on the display will display the hour, the power, and the
planned set temperature.
Note: If the new stove, when its first time using, it is necessary to put a hand of pellet to the fire pot
before hand.
Note: if the ignition is failure, the thermal control will shut off the stove automatically. Meanwhile, E2 (Error for
the ignition failure), will be turned on the display, If want to restart it again, Please Check the stove as usually
and cleaning the fire pot. After that, you have to push
to ignite and start again.
make sure the stove is under your
for two seconds,
!! ATTENTION !!
to clean the Phrase E2. Follow the above process
15
eyes, until its