Bauhaus Tossi 8 Instrucciones Para La Instalación, Uso Y Mantenimiento página 100

Switching on / switching off
The heater switching on and switching off is
performed through the ON/OFF key
After switching on,
"CLEANING" will be shown on first, in order
to clean the fire pot.
In the same way, push
switching off Period, the message shows:
↓
→
After the temper ature in the stove is cold
enough, finally, the phrase' GOODBYE' is
displayed.
During the flame switching off phase and exchanger cooling, Normally it isn't allowed to switch on again
the heater up to the operation end; this state is highlighted from the message 'SWITCHING OFF'
The switching on Stage, which has the duration of
about 5-15 minutes, are necessary to the resistance
to carry the pellets at the switching on temperature,
(depends from the heater). The switching on
→
procedure is showed from a passage set showed in
the display as previous one and then:
the message,
, then at the
Thirdly,After second phase is showed from the
message 'FEEDING'. In this phase are performed
the chimney verification operations and the pellets
will be loaded in the melting pot. The successive
phase will be showed from the inscription
"Lighting". This state remains up to when the
←
smokes temperature doesn't exceed the planned
threshold.
When the Lighting phase is finished, some
minutes will spend necessary for the flame
stabilization. This phase is showed from the
message 'STABILIZATION" which finishes
↑
after some minutes going up at the work phase
!! ATTENTION !!
14
↓ →
→ ↓ →