Filling The Water Heater; Initial Operation - Thermor AEROMAX SPLIT 2 Manual De Instalación

Warnings
6.

Filling the water heater

Open the hot water tap(s).


Open the cold water tap on top of the safety unit (ensure the safety unit's drain valve
is closed).

Close the hot water taps after draining them. The water heater has been filled with
water.

Check if the connection is tight at the pipe sockets and if the hydraulic components
function properly by repeatedly opening the safety unit's drain valve to remove pos-
sible residues from the drain valve.
7.

Initial operation

Mode selection
and operating
settings
Gradual increase
of hot water
production
Turn the power on to the water heater.

When you do so for the first time, the setting instructions will be displayed.

Follow these instructions carefully to make the respective settings
(Language, date and time, operating ranges, legionella-function, Full or partial
commissioning, Overview of settings).
In order to return to the settings later, please refer to Section "Installation parameters".
For initial heating, activate the BOOST function (irrespective of the set operating range).
Presentation
Installation
Please take a few minutes
to adjust the settings
Continue
Installation
Information
Instructions
Increase/navigate
Confirm
Back
Reduce/navigate
25