Usb; Disc Playback - Yamaha MCR-750 Manual De Instrucciones

TROUBLESHOOTING
Problem
The iPod does not
charge up.

USB

Note
In case of a transmission error without a status message appearing on the front panel of this unit, check the connection to the USB
device (refer to page 13).
Status message
USB ERROR
Problem
The file in the USB
device does not play.

Disc playback

■ General
Problem
No sound or
distorted sound.
44
En
Cause
The iPod is not connected correctly.
The iPod is not supported by this unit.
Cause
The connected USB device is not
playable on this unit.
The USB device is connected at an
angle.
Cause
The USB device is not recognized.
Incorrect USB device connections.
The file format is not compatible with
this unit.
If the solutions above do not resolve the
problem, the USB device is not playable
on this unit.
Cause
The sampling rate of an audio or video
file is not compatible with this unit.
Remedy
Connect the iPod and this unit by a USB cable
correctly.
Only iPod classic, iPod nano (2nd, 3rd, 4th, 5th and
6th generation), iPod touch (1st, 2nd, 3rd, and 4th
generation), iPhone, iPhone 3G/3GS, iPhone 4, and
iPad are supported.
Remedy
Disconnect the USB device. Change input source
other than USB and select USB as input source
again. Then connect playable USB device again.
Remedy
Connect the USB device again.
Connect an AC adapter if supplied with the device.
Connect the USB device again.
Replace the file with a correctly recorded file
playable with this unit.
Try another USB device.
Remedy
Check that the sampling rate and bit rate of an audio
or video file are compatible with this unit.
Audio may not be output depending on the audio
recording status, such as when audio other than an
audio signal or non-standard audio is recorded for
the audio content.
There is no sound during still mode, slow motion
playback, fast forward and fast reverse.
Page
11
11
Page
13
Page
13
—
13
3
—
Page
3
3
—