Setting U P Your Humid Aire 3I For Use; Removing The Front Cap ( If Fitted ); Removing And Storing The Connector Plug; Attaching Your Humid Aire 3I - ResMed HumidAire 3i Manual Del Usuario

S
ETTING
WARNING
!
Make sure your flow generator is switched off at the power outlet before
connecting the HumidAire 3i.
R
EMOVING THE FRONT CAP
Please refer to the illustrations in section B of the illustration sheet.
Your flow generator may be fitted with a front cap (B-1). Before you can attach the
H
UMID
the body of your flow generator (B-3 & B-4).
Notes
To replace the front cap, align it with your flow generator (B-4) and push it firmly until it
•
clicks into place.
Remember to take the front cap with you when travelling, in case you need CPAP
•
therapy without a humidifier.
R
EMOVING AND STORING THE CONNECTOR PLUG
Please refer to the illustrations in section C of the illustration sheet.
Before attaching the H
generator (C-1) and attach it to the back of the docking station (C-2).
A
TTACHING YOUR
Please refer to the illustrations in section D of the illustration sheet.
1
Align your H
until they click into place (D-2).
WARNING
!
The HumidAire 3i docking station should only be connected or disconnected
•
when the water chamber is empty.
Water must be prevented from entering your flow generator. Do not transport
•
the flow generator with the HumidAire 3i attached.
2
Insert the power cord into the socket at the rear of your flow generator. Plug the other
end of the power cord into a power outlet (D-3).
Note: If your flow generator is powered via the DC input, the HumidAire 3i is not powered
and humidification output will be reduced.
3
Place the combined unit on a firm, level surface near your bed at a level lower than
your sleeping position. Ensure the surface is not sensitive to heat and/or moisture, or
use a protective mat.
CAUTION
!
Be careful not to place the unit where it can be bumped into and knocked over.
6
U H
P YOUR
(
3i, press the button underneath the front cap (B-2) and pull it away from
A
IRE
UMID
H A
UMID IRE
A 3i with your flow generator (D-1) and push them together
UMID IRE
A
UMID IRE
)
IF FITTED
A 3i, remove the connector plug from your flow
IRE
3i
3i F U
OR SE