Luminance Brands Kathy Ireland Home CF985LBS00 El Manual Del Propietario página 7

3. Ceiling Fan Assembly
3.7
Route the 80" Black and White Motor Wires through the
Ceiling Cover (Figure 6).
Place the Ceiling Cover over the Downrod. Be sure
both the Ceiling Cover and the Coupler Cover are
oriented correctly (Figure 6).
3.8
NOTE: Only use the Hanger Ball supplied with this
Ceiling Fan.
Route the two 80" Motor Wires through the Hanger Ball.
Reinstall the Hanger Ball (Figure 7) on the Downrod as
follows:
Position the Hanger Ball Pin through the two Holes in
the Downrod and align the Ball so the Pin is captured in
the Groove in the top of the Hanger Ball.
Pull the Hanger Ball up tight against the Pin and
securely tighten the Set Screw in the Hanger Ball.
NOTE: A loose Set Screw could create Fan wobble.
3.9
The Fan comes with Black and White Wires that are
80-inches long.
Before installing the Fan, measure up approximately
6 to 9-inches above top of Hanger Ball/Downrod
Assembly (Figure 8).
Cut off excess Wires and strip back insulation 1/2-inch
from end of Wires.
You have now completed the initial assembly of your
new Ceiling Fan. You can now proceed with hanging
and wiring your Fan.
(Continued)
Figure 6
PIN
Figure 7
1/2-INCH
6 TO 9
INCHES
Figure 8
Please contact 1-800-777-4440 for further assistance
7
6" DOWNROD
CEILING
COVER
6" DOWNROD
HANGER
BALL
SET SCREW
BLACK WIRE
WHITE WIRE
HANGER BALL/
DOWNROD
ASSEMBLY
luminancebrands.com
ETL Model No.: CF985L