Light Kit Assembly; Important - Craftmade FB60 Guia De Instalacion

9. Light Kit Assembly.

Remove 1 screw from fitter plate (on the
underside of the motor housing) and
partially loosen the other 2 screws.
Connect WHITE wire from light kit fitter to
WHITE wire from motor housing. Connect
BLACK wire from the light kit fitter to BLACK
(or BLUE) wire from the motor housing. Be
sure that the molex connections snap
together securely.
Align slotted holes in light kit fitter with
loosened screws on fitter plate. Twist light kit
fitter to lock. Re-install screw that was
previously removed and then securely
tighten all 3 screws.
Install 3 candelabra base 40 watt max.
incandescent bulbs (included).
IMPORTANT: When replacing bulbs, please
allow bulbs and glass shade to cool down
before touching.
Remove finial, finial plate and threaded
washer from threaded rod on light kit fitter
and save for later use.
Align hole in glass shade with threaded rod
and push up gently until threaded rod
comes through hole. Secure glass shade with
threaded washer that was previously
removed. Do NOT overtighten threaded
washer as glass may crack or break.
Align hole in center of finial plate with
threaded rod and push up. Re-attach finial
being careful to NOT overtighten as glass may
crack or break.
fitter plate
bulb
threaded
rod
finial plate
page 8
motor housing
molex connections
light kit fitter
glass shade
threaded washer
finial