Tabla de contenido
Idiomas disponibles
Idiomas disponibles
11. Automated Learning Process./Activating Code.
CAUTION: The wall and/or handheld remote control can be programmed
to multiple receivers or fans. If this is not desired, turn wall switch off to any
other programmable receiver or fan.
Restore electrical power and then, if using wall control, set slider switch
on wall control to the ON position. Within 60 seconds of turning on the
wall control, press and hold the fan OFF button on the wall control for
5 seconds (or until lights blink twice or fan blades begin to turn).
Turn power off again for at least 5 seconds and then turn power back
on. Within 60 seconds of restoring the power, press and hold the fan
OFF button on the front of the handheld remote control for 5 seconds
(or until lights blink twice or fan blades begin to turn).
Test the light and fan functions to confirm the learning process is
complete--see Section 13 below.
12. Remote Control Operation.
ON/OFF slider switch - turns wall control ON or OFF
HIGH button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
OFF button - turns fan OFF
L1 button - turns light kit ON/OFF when pressed once;
dims light kit when pressed and held down
L2 button - (not applicable for this fan)
REV button - used to REVERSE blade direction
(fan must be set on low before reversing blade
direction)
13. Testing Your Fan.
It is recommended that you test fan before finalizing installation.
Restore power from circuit box and light switch (if applicable).
Test wall control (optional installation) by locating ON/OFF slider
switch on wall control, then set to the ON position. Test light and
dimmer function and then test fan speeds. Next, locate handheld
remote control. Test the light ON/OFF function by pressing the
L1 button; test the dimmer function by pressing the L1 button
and holding it down for more than 1 second. Test fan speeds
with the different fan speed buttons. If the wall and/or handheld
remote control operate(s) all of the functions of the fan, battery
has been installed correctly in (each) remote. If the wall and/or
handheld remote control do (does) not operate all of the
fan/light functions, refer to "Troubleshooting" section to solve
any issues before contacting Customer Service.
Fan must be on LOW before setting the fan to reverse direction.
Use "reverse" button to recirculate air depending on the season.
NOTE: If the wall control/handheld remote control interferes with
other appliances, turn off power and go back to the instructions
in Section 11 above.
(switch not functional on handheld remote)
-
1 1
-
2 2
wall control
handheld
remote control
Capítulos
Tabla de contenido
