1byone 471UK-0010 Manual De Instrucciones página 6

Anti-skating Force Adjustment
EN
The anti-skating force must be adjusted corresponding to the tracking force as follows:
DE
Tracking Force Groove in the Stick
FR
5-10 mN 1st from bearing ring
10-15 mN 2nd from the bearing ring
ES
15-20mN 3rd from the bearing ring
IT
>20mN 4th from the bearing ring
1. Slip the loop of the anti-skating weight's
3rd
thread over the groove of the stick
to set the correct anti-skating force for
the factory-installed cartridge.
Connecting to Speakers
1. Connection to the Included Speakers
This turntable includes a built-in preamp and comes supplied with Hi-Fi speakers.
Connect the speakers using the included audio cable (black cable to black cable
clamp and red cable to red cable clamp).
④ ③ ② ①
2. Feed the thread through the loop of
the wire hanger.
8
2. Connection to External Speaker with the RCA Audio Cable
If you wish to use your own amplifier or speakers, please follow the instructions
below:
2.1 Setting pre-amplifier selector switch
This product has a built-in phono equalizer function. You can use the product
even if you do not have a phono amplifier or connectable equipment with a
built-in phono amplifier.
Use the pre-amplifier selector switch to set the output, as shown below.
Connectable equipment Position of pre-amplifier
being used selector switch
Device with phono input PHONO
Device without phono LINE
input
When connecting via the included speakers, using the pre-amplifier selector
switch is not necessary.
NOTE: The RCA Jacks are not designed to be connected directly to the
passive/unpowered speakers on LINE mode. If connected to the passive
speakers, there will be no sound.
RCA wired connection
Active Speakers
or
Amplifier
Where to connect RCA
audio cable
Phono input jack and
ground (earth) terminal of
connectable equipment
AUX or line input jack of
connectable equipment
9
EN
DE
FR
ES
IT