Porsche Wall Charger Connect Manual De Funcionamiento E Instrucciones De Instalación página 15

The following overview contains recommendations for dealing with malfunctions that restrict or prevent the vehicle from charging.
Situation
The display (screen, status LEDs, Power button) has
stopped working completely.
The display is blank, the status LEDs do not change color
and the Power button lights up red.
Restricted operation or charging not possible (message
on display).
The charging current is too low (message on display).
The grid voltage is too high (message on display).
The charger is not within the permitted temperature
range (message on display).
The circuit breaker in the domestic installation was
triggered (message on display).
Recommended action
e Disconnect the charger from the power grid and check the fuse.
e Have the domestic installation checked by a qualified electrician.
e If the error persists, have the charger replaced.
e The charger is overheated. Disconnect the charger from the power grid and let it cool down slowly by
itself.
e If the error persists, have the charger replaced.
e Make sure that the charger is within the permitted temperature range. Please see chapter "Technical
Data" on page 21.
e Acknowledge any error message that appears.
e Start the charger again. Press the Power button for at least 10 seconds to start the charger again.
e The home network is overloaded. Switch off other high-usage electrical loads.
e Have the domestic installation checked by a qualified electrician.
e Device temperature switch-off: Avoid direct sunlight and let the charger cool down slowly by itself.
e Low-temperature switch-off: Let the charger heat up in a warm environment before using it.
e Device temperature sensor faulty: Have the charger replaced.
e Reduce the charging current in the settings on the charger.
e Acknowledge any error message that appears.
Operating Instructions
US
FC
ESM
13