Wayne Dalton TorqueMaster Plus 9100 Instrucciones De Instalación Y Manual Del Propietario página 30

27
Attaching Disconnect Handle
NOTE: See idrive
Tools Needed:
instructions and owner's manual for
Phillips head
idrive
®
screwdriver
NOTE: Bring motor to the down position
Wire cutters
by pulling the disconnect cable, insure
opener disconnect teeth are engaged
before installing disconnect handle.
Start the #6-20 x 1/2" screw into the
disconnect handle. Thread the
disconnect cable through the top of the
disconnect handle bracket and then the
disconnect handle.
Locate the disconnect handle in full
upper position of disconnect handle
bracket.
Remove all disconnect cable slack
between the opener and the top of the
disconnect handle bracket. Tighten
#6-20 x 1/2" screw into the disconnect
handle until snug, and then tighten
screw an additional 1 to 1-1/2 turns to
secure disconnect cable to the
disconnect handle. Trim off excess cable
from bottom of the disconnect handle.
CAUTION: PULL CABLE ONLY TAUT
ENOUGH TO REMOVE THE CABLE SLACK.
PULLING THE CABLE MORE COULD
CAUSE OPENER TO DISCONNECT FROM
THE TORQUEMASTER
Apply emergency disconnect label next
to the mounted bracket. Use
mechanical fasteners if adhesive will
not adhere.
Using the emergency disconnect, pull
disconnect handle downwards and
place it in the manual door operated
position (Use disconnect label for
reference). Motor will be rotated 90°
from its packaged position.
If motor does not pivot 90°, see
troubleshooting section in the main
installation instructions and owner's
manual of your idrive
30
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
main installation
®
parts.
SPRING TUBE.
®
opener
®
UPPER POSITION
#6-20 X 1/2"
SCREW
HANDLE
DISCONNECT
CABLE
DISCONNECT
HANDLE
BRACKET
MANUAL OPERATED POSITION
EMERGENCY DISCONNECT
LABEL
MOTOR OPERATED POSITION