Assembly - Husqvarna ECA850 Manual Del Usuario

2. Tighten the locknut using a socket wrench to
15-20 Nm / 11-20 ft-lb.
Safety instructions for maintenance
WARNING: Read the safety instructions
that follow before you use the product.
To install the front guard, battery
power units
1. Install the front guard on the front of the cutting
attachment guard.
2. Attach the bolt and tighten it.
To assemble the bevel gear
1. Insert the driveshaft into the bevel gearbox
housing. Turn the cutting attachment so that the
shaft engages in the bevel gear.
2. Attach the bevel gear box to the shaft tube
aligning the positioning holes.
3. Fasten the screw (A), then fasten the clamp bolt
(B) firmly, 6-8 Nm / 53-70 in-lb.
a) For model ECA850:
1153 - 001 - 22.08.2019
• Always stop the engine/motor before you do
work on the cutting attachment. The blade
continues to move after the throttle/power trigger
is released. If you have a gasoline operated
product, remove the spark plug cap from the
spark plug. If you have a battery operated
product, remove the battery. Make sure that the
cutting attachment has stopped fully before you
do work on it.
• Always wear heavy duty gloves when you repair
the cutting attachment. This is very sharp and
can easily cause cuts.
• Use only original spare parts for repairs.
• Keep the product away from children
SAVE THESE
INSTRUCTIONS

Assembly

b) For model ESA850:
B
To assemble the cutting attachment
WARNING: Never use a cutting
attachment without without an approved
cutting attachment guard. If an incorrect
or faulty cutting attachment guard is
fitted this can cause serious personal
injury.
A
B
A
7