Caller Id Solutions - GE THOMSON 21098 Guía De Uso

• Unplug the power adaptor from the electrical outlet and the back of the
base. Remove the handset battery. Wait for 30 seconds and plug the
power adaptor back into the base and electrical outlet. Reconnect the
battery and charge for 16 hours.
Handset displays SEARCHING or OUT OF RANGE and cannot link up with
the base when TALK/END/call back button is pressed.
• Handset may be out of range from the base. Move closer to the base.
• Make sure the power adaptor is properly installed.
• Disconnect the handset battery and plug it again. Place the handset on
the cradle for at least 2 to 3 minutes.
• Disconnect the power adaptor and plug it in again. Then place the
handset on the cradle for at least 2 to 3 minutes.
Handset displays HANDSET NEEDS REGISTRATION.
• Follow the programming in the telephone procedures to re-register the
handset to the base.
• Press the SELECT button to start the registration and follow the
procedure.

Caller ID Solutions

No Display
• Charge the battery (for 16 hours). Or replace the battery.
• Make sure the unit is connected to a non-switched electrical outlet.
Disconnect the power adaptor from the base and reconnect it.
Caller ID Error Message
• The unit displays this message if it detects anything other than valid
Caller ID information during the silent period after the first ring. This
message indicates the presence of noise on the line.
No Caller ID
• You must be subscribed to the standard Name/Number Caller ID service
from your local telephone company to receive CID information.
69