Reference Figures - Target ECONOLINE II 18W Instrucciones De Operación Y Lista De Piezas

Tabla de contenido
DIAGRAM 1
1A
RAISE / LOWER HAND WHEEL:
1B.
WATER SAFETY SWITCH: Stops the engine if the
water supply to the blade is interrupted. Push to
reset.
1C.
WATER PUMP SWITCH:
1D.
FUEL TANK FILL: Fill the fuel tank at this location.
1E.
ENGINE KEY SWITCH: Start the engine using this
switch.
1F.
DRIVE WHEEL ENGAGE LEVER:
NEUTRAL POSITION: The saw will stop travel
movement when the speed control lever (1J) is in this
position. The engine will not start unless the Speed
Control Lever (1J) is in the NEUTRAL position.
1G.
HOURMETER:
1H.
HANDLE BARS: For operator gripping.
1I.
KNOB: Use to tighten operator grip handles.
1J.
SPEED CONTROL LEVER: Controls forward and
reverse directions, stop, and the speed of the saw.
1K.
BLADE DEPTH INDICATOR:
depth.
1L.
BLADE DEPTH CONTROL LOCK: Sets the depth
stop for repetitive cuts at the same depth.
16
DIAGRAM 2
2A.
2B.
2C.
2D.
2E.
2F.
2G.
2H.
2I.
Displays cutting
BLADE SHAFT NUT:
flange against the diamond blade.
OUTER FLANGE: Use to hold the diamond blade in
position.
NOT USED
LOCKING PIN: Use to prevent the diamond blade
from rotating on the shaft during operation.
DIAMOND BLADE:
Use as the cutting tool for
concrete and asphalt surfaces.
INNER FLANGE: Inside support used to hold the
diamond blade in position.
BLADE GUARD NOSE LATCH: Use to latch the
front of the blade guard in the down position.
BLADE GUARD FRONT: The front section of the
blade guard.
BLADE SHAFT: Supports the blade flanges and
blade.
Use to tighten the outer
Tabla de contenido
loading

Tabla de contenido