Tabla de contenido
WARNING:
INSTRUCTIONS COULD RESULT IN DEATH OR SERIOUS BODILY INJURY.
DO NOT
operate this machine unless you have read and understood this operator's manual.
DO NOT
operate this machine without the blade guard, or other protective guards in place.
DO NOT
stand behind or in front of the blade path while the engine is running.
DO NOT
leave this machine unattended while the engine is running.
DO NOT
work on this machine while the engine is running.
DO NOT
operate this machine when you are tired or fatigued.
DO NOT
use a wet blade without adequate water supply to the blade.
DO NOT
exceed maximum blade speed shown for each blade size. Excessive speed could result in blade breakage.
DO NOT
operate the machine if you are uncertain of how to run the machine.
DO NOT
use damaged equipment or blades.
DO NOT
touch or try to stop a moving blade with your hand.
DO NOT
cock, jam, wedge or twist the blade in a cut.
DO NOT
transport a cutting machine with the blade mounted on the machine.
DO NOT
use a blade that has been dropped or damaged.
DO NOT
use carbide tipped blades.
DO NOT
use abrasive blades.
DO NOT
use conventional abrasive blades with water.
DO NOT
touch a dry cutting diamond blade immediately after use. These blades require several minutes to cool after each cut.
DO NOT
use damaged or worn blade flanges.
DO NOT
allow other persons to be near the machine when starting, refueling, or when the machine is in operation.
DO NOT
operate this machine in an enclosed area unless it is properly vented.
DO NOT
operate this machine in the vicinity of anything that is flammable. Sparks could cause a fire or an explosion.
DO NOT
allow blade exposure from the guard to be more than 180 degrees.
DO NOT
operate this machine while using drugs or alcohol.
DO NOT
operate this machine with the belt guard or blade guard removed.
DO NOT
operate this machine unless you are specifically trained to do so.
DO NOT
use a blade that has been over heated (Core has a bluish color).
DO NOT
jam material into the blade.
DO NOT
grind on the side of the blade.
DO NOT
lay power cords in or near the water.
DO NOT
tow this machine behind a vehicle.
DO NOT
leave the machine unattended with the motor running.
DO NOT
replace the motor with any motor that does not have a special grounding connection.
DO NOT
use the tie down brackets for lifting this machine.
DO NOT
operate this machine with the transmission guard removed.
DO NOT
cut deeper than 1" per pass with a dry blade. Step cut to achieve deeper cuts.
This saw was designed for certain applications only. DO NOT modify this saw or use for any application other than
for which is it was designed. If you have any questions relative to its application, DO NOT use the saw until you
have written Diamant Boart, Inc. and we have advised you.
SAFETY FIRST!
WARNINGS
DO's AND DO NOT's
FAILURE TO COMPLY WITH THESE WARNINGS AND OPERATING
*****************
DO NOT
Diamant Boart, Inc.
17400 West 119th Street
Olathe, Kansas 66061
13
Tabla de contenido
