Drum And Drum Lift Bar Assembly - Delta 50-905 Manual De Instrucciones

dRUM ANd dRUM LIFT BAR ASSEMBLY

TOOLS REqUIREd
• 5/16" wrench
• Slotted screwdriver
• ½" wrench
• 3/8" Allen wrench
• 9/16" wrench
• 11/16" wrench
• Remove drum suction ring from the bottom of the
drum (see Fig. 6A) and set aside.
• Lay drum on its side and feed the threaded end of
the drum casters through the holes in the bottom of
the drum.
• Secure casters from the inside of the drum using a
3/8" hex nut, 3/8" lock washer and 3/8" flat washer.
• Turn drum right side up and install the drum cover
gasket by fitting the grooved side of the gasket over
the lip of the drum, as in Fig 6B
• Use a razor knife to trim excess gasket.
• Re-install drum suction ring making sure the
smaller-diameter end of the ring is at the bottom of
the drum.
• Attach the drum lift bar by fitting the large holes
(A) on either side of the lift bar over the two pins
located on the lift supports. See Fig. 7.
• Raise the lift support arm so that the hole in the arm
aligns with the hole in the drum lift bar (B). See Fig. 7.
• Secure lift support arm to drum lift bar using the
3/8" x 21mm x 12mm hex head screws and 3/8" hex
lock nutusing a 9/16" wrench and 11/16" wrench.
Repeat with the other lift support arm. Do not
overtighten nuts.
ASSEMBLY
hARdwARE NEEdEd
• 5/16" hex nut (10)
• 5/16" lock washers (10)
• 5/16" flat washers (4)
• M8 x 30mm flat head hex screws (2)
• 3/8" x 21mm x 12mm hex head screws (2)
• 5/16" hex nuts (2)
• 5/16" x ¾" Phillips Head Screws
FIg. 7
NOTE: There will be some play between the lift support
arm and the lift support. This is normal.
NOTE: Keep this area clean and lubricate with spray
silicone as needed to provide smooth operation of the
lift mechanism.
Pin located on the lift support. There is another one on
the left side as well.
10
FIg. 6A
FIg. 6B