American Standard Advanced Clean 3.0 SpaLet Manual Del Usario página 35

Cleaning the Areas of the SpaLet
1. Remove the power plug from the wall
outlet. (See caution 1.)
3.
Water shuto valve
1 Pull the lock lever on the right side of the seat unit.
Slide this product forward, raise it slightly, and remove it
2
from the SpaLet seat. (See caution 2, 3 and 4.)
2
Slide
forward
* When removing this product, slide the unit slowly without holding the SpaLet seat or
seat lid. Do not use excessive force.
CAUTION
1. Remember to remove the power plug from the wall outlet.
* If the water heater operates with no water in the tank, it
could cause smoke or fire.
2. Do not pull on any cord or water supply hose.
* Doing so may lead to damage or a water leak.
3. Carefully handle the seat unit when removing or cleaning.
* Failure to do so may lead to water leakage.
4. Never turn the seat unit upside down while it is
connected to the power supply.
* It could cause damage to this product.
* Do not reverse
* Do not place on
the floor.
Seat That Are Covered by the Seat Unit
®
1. Removing the seat unit
Turn clockwise.
Lock lever
Lock lever
* Do not pull.
2. Close the water shut-off valve to cut off the water
supply. (See caution 2.)
Since the water shut-off valve is adjusted beforehand,
keep track of the turns so you can return the valve to
its original position.
4. Carefully place the seat unit on
the rim of the toilet bowl.
Lock lever
1
● Do not pull.
Water shut-off
valve
Turn clockwise
Hold the lower part of the
SpaLet seat and pull.
● Do not reverse
● Do not place on
the floor.
32 - EN