Locking The Safe; Selecting A Location - STACK-ON SS-22-MB-E Manual De Instrucciones

LOCKING THE SAFE

To lock the safe, close the door and rotate the
handle counter clockwise until it stops. If the
handle is not turned until it stops, the locking
mechanism will not lock.
NOTE ON LOCKING THE SAFE: Because
the locking mechanism is deactivated for
approximately 3 to 6 seconds after the
combination is entered, wait a minimum of 6
seconds from the time the combination is entered
to lock the safe.
TURNING THE KEYPAD SOUND OFF/ON
You can turn off the "Beep" sound of the keypad by
6 3 3.
entering the code
To turn the "Beep" sound on, enter the code

SELECTING A LOCATION

The safe must be mounted to the floor. For
optimal safety and security, the safe should be
installed adjacent to a side wall with minimal
space on either side of the safe, in an isolated,
dry and secure area.
The safe should be flat against the wall and floor.
Remove the baseboard if necessary.
CHILDREN SHOULD NOT PLAY
WITH OR AROUND THE SAFE AT
ANY TIME.
SECURING THE SAFE
NOTE: The safe must be secured to the floor.
Use the hardware provided or consult your
hardware retailer for fastening hardware for your
particular mounting surface.
NOTE: This safe must be mounted to the floor.
Failure to do so will compromise the safety and
security of the safe.
Mark the holes to be used. Drill the appropriate
diameter and depth of pilot holes depending on the
type of hardware being used and the type of
mounting surface.
Secure the safe with the fasteners.
6 6.
3
18
40248-1312