Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5. Influential factors on lifting capacity
Air-gap
It corresponds to the space between the magnet lifter active poles and the load due
to surface roughness, oxidation, paper or painting on the load, flashes, etc.
A rusted hot laminated plate presents an air-gap between 0.1 to 0.3 mm. Surface
roughness of a piece in wrought iron can reach 0.5 mm.
Permanent magnet lifter capacity is reduced when the air-gap increases (see tables
in following paragraph).
Dimensions of the load (see tables in following paragraph)
Thickness and contact surface : a load too thin or a contact which doesn't cover all
the active poles surface, doesn't allow a good closing of the magnetic circuit and
reduces the magnetic force on the load.
IMPORTANT : presence of holes with important dimensions also limits the magnet
lifter capacity.
Length: bending of the load due to its long length produces an air-gap.
Load horizontality
To achieve the maximum capacity of a magnet lifter, loads must be perpendicular to
the active poles surface. That is why it is necessary to find out, with a good
positioning of the magnet lifter, the best horizontal position of the load before lifting.
Kind of load
Steel type *
Low carbon content
(E24-2, S235)
St 52 (A50-2)
96 %
Stainless steel 430F 50 %
Fonte
45 %
Nickel
10 %
Stainless steel 304
* non exhaustive list
** % regarding maximum working load limit of magnet lifter with steel with low
carbon content (like S235 steel) with a surface quality which warrants a surface
roughness ≤ 0,1 mm (smooth and clean manufactured surface) and for loads
dimensions which respect characteristics given the « practical tables for capacity
reduction ».
magfor
magfor
%**
100
300
100
100
300
%
96
288
50
150
45
135
10
30
0 %
0
0
WLL (kg)
magfor
magfor
magfor
500
1000
2000
500
1000
2000
480
960
1920
250
500
1000
225
450
900
50
100
200
0
0
0
WLL: working load limit
magfor
magfor
3000
5000
3000
5000
2880
4800
1500
2500
1350
2250
300
500
0
0
13
Tabla de contenido
