Tabla de contenido
Idiomas disponibles
Idiomas disponibles
A missing or improperly installed battery will prevent the battery carrier from
closing and result in improper alarm operation.
This smoke alarm uses a 9V carbon zinc battery (alkaline and lithium batteries
may also be used). A fresh battery should last for one year under normal operat-
ing conditions.
This alarm has a low battery monitor circuit which will cause the alarm to
"chirp" approximately every 30-40 seconds for a minimum of seven (7) days
when the battery gets low. Replace the battery when this condition occurs.
PRESS
USE ONLY THE FOLLOWING 9 VOLT BATTERIES FOR SMOKE ALARM
REPLACEMENT.
(These batteries are available at many local retail stores).
Carbon-zinc type:
Alkaline type:
Lithium type:
NOTE: WEEKLY TESTING IS REQUIRED!
NOTE: IF AFTER BATTERY REPLACEMENT THE ALARM CONTINUES TO
CHIRP, PUSH THE TEST BUTTON. THE HUSH
ACTIVATED ACCIDENTLY WHILE CHANGING THE BATTERY AND PUSHING
THE TEST BUTTON WILL END THE HUSH
WARNING! BE SURE TO FOLLOW BATTERY INSTALLATION INSTRUCTIONS
PRINTED ON THE BACK OF THE ALARM AND USE ONLY THE BATTERIES
SPECIFIED. USE OF DIFFERENT BATTERIES MAY HAVE A DETRIMENTAL
EFFECT ON THE SMOKE ALARM.
OPEN
EVEREADY 216 OR 1222; GOLD PEAK 1604P OR 1604S
ENERGIZER 522; DURACELL MN1604 OR MX1604;
GOLD PEAK 1604A PANASONIC 6AM6, 6AM-6, 6AM-6PI,
6AM6X, AND 6LR61 (GA)
ULTRALIFE U9VL-J
®
FEATURE MAY HAVE BEEN
CYCLE.
®
INSERT
Tabla de contenido
