First Lid Opening And Emergency Opening; Connection To The Mains; Rotor Positioning - Selecta MACROTRONIC BLT Manual De Instrucciones

MANUAL DE INSTRUCCIONES
Make sure to fit the pin of the motor
shaft in its housing.
J
.P. SELECTA s.a.u.
CÓDIGO 80316
DO NOT INSTALL THE EQUIPMENT IN EXPLOSIVE ATMOSPHERES OR PLA-
CES WHERE SUBSTANCES LIABLE TO FORM EXPLOSIVE OR FLAMMABLE
MIXTURES ARE USED OR STORED.
6.2

First lid opening and emergency opening

Upon receiving the centrifuge, the network connection cable is inside the tank and
therefore the only way to open the equipment is following these instructions:
- Remove the equipment side plastic caps.
- Gently push from both caps, and the lid will open.
USE THIS OPENING SYSTEM FOR EMERGENCY OPENING ONLY.
NEVER use the device emergency opening when the
engine is rotating.
6.3

Connection to the mains

Make sure that the equipment is connected to the mains and that the voltage coincides
with the indicated on the features plate.
Do not use an equipment without being earthed.
Only use the supplied cable for network connection.
6.4

Rotor positioning

Before starting the centrifuge, ensure that you have placed the rotor in a proper way,
otherwise it could cause damages on the equipment.
Firmly tighten the nut of the rotor with the
provided key.
Ctra. NII Km 585.1 Abrera 08630 (Barcelona) España
e-mail: [email protected] - website: http://www.jpselecta.es
REV C
Place the adapters and tubes evenly.
Tel 34 937 700 877 Fax 34 937 702 362
05/2020 Pag.: 12