Ivoclar digital PrograMill Dry Instrucciones De Uso página 88

EN 40
Does the air pressure fluctuate significantly so that
jobs are frequently interrupted?
If applicable:
1. Verify that your compressor can
erate the required air pressure and volume flow.
Not every compressor is designed for
commercial use with dental machines.
2. If necessary, replace your compressor with one
that meets the recommendations.

Installing the pneumatics
The computer interrupts the job and displays
that the vacuum is too low
You can resolve this problem while the job
execution is interrupted. PrograMill CNC
continues the job as soon as the problem is
resolved.
Is the suction unit switched on and operating?
How to check this:
1. Check if the suction hose is properly seated in the
corresponding opening and is undamaged.
2. If the machine controls the suction unit:
a. Check if the switching unit or data cable is
properly installed.
b. For test purposes, run the suction unit
without the switching unit or the data cable.
3. Switch on the suction unit.
4. Set the extraction level higher until the machine
continues the job.
Is the filter or container of the suction unit full?
If applicable:
Insert an empty filter into the suction unit or empty
the container.
Does the suction unit have an automatic tapping
function?
If applicable:
Choose a shorter tapping interval.
I have exchanged the tool magazine inserts and
now there are no holes for the tools anymore
Tool magazine inserts are delivered without drilled
holes for tools. You drill them with the machine.
Use PrograMill CNC to drill new holes into the new
inserts.
permanently gen-
– on page 16
Operating Instructions: PrograMill Dry Version: 2/19/2021
PrograMill Dry – Troubleshooting guide