Ivoclar digital PrograMill Dry Instrucciones De Uso página 52

EN 4
While in any "Service Mode": Everyone
within reach of the machine must wear pro-
tective eye wear.
Hearing damage due to loud noise
If you are regularly exposed to loud machining noise,
you may suffer from hearing loss and tinnitus.
If loud noise cannot be avoided, wear ear
protection during machining.
Risk of injuries through loose pneumatic components
under air pressure when connections are open
Loose pneumatic components can move extremely
fast and unpredictably and may cause injury.
Before you run the pneumatic hoses, close the
compressed air supply valve.
Before you check the pneumatic hoses and pneu-
matic connections, set the air pressure to a min-
imum value.
In case of defective machine connections
and pneumatic hoses, disconnect the
machine from the external compressed air supply
and the electrical source.
Contact your service partner if connections are
damaged or defective.
Risk of injuries when opening or closing the working
chamber door
When you open or close the working chamber door,
the moving working chamber door may crush your
fingers. Objects on the machine may fall and cause
injuries or damage.
Trip, fall and slipping hazards
Risk of cutting injuries and burns
If you touch tools or sharp edges on materials or the
machine, you may suffer from cuts. If you touch the hot
spindle body or hot tools, you may suffer from burns.
Reduced ability to act with insufficient lighting
In case of an insufficient lighting your judgment and /
or your precision may be reduced.
Risk of injury in case of malfunctions caused by
insufficient maintenance
If you do not maintain the machine as required,
malfunctions may occur which can lead to injuries.
Health risks through constant malpositioning if your
working environment is not sufficiently ergonomic
Over the long run, an improper or one-sided posi-
tioning can be a risk to your health.
Operating Instructions: PrograMill Dry Version: 2/19/2021
PrograMill Dry – General safety instructions
CAUTION
When you open and close the working chamber
door, use one hand and keep the other hand away
from the machine.
When you close the working chamber door, ensure
your hands do not get caught between the door
and the machine housing.
Do not place objects on the machine.
Run cables in such a way that persons can-
not trip over them.
Keep the working environment and instal-
lation site clean.
Wear gloves when you perform manual work
at the machine or materials / tools.
Ensure that the lighting in your working envi-
ronment is sufficient.
Take note of the intervals and conditions men-
tioned in the maintenance table in the operating
instructions. Carry out the respective maintenance
tasks accordingly.
Set up an ergonomic work environment.
Ensure the seat height and monitor position is
ideal and the lighting is sufficient.