Managing Tools; Inserting And Exchanging Tools - Ivoclar digital PrograMill Dry Instrucciones De Uso

PrograMill Dry – Operation: Preparing jobs

Managing tools

NOTICE
Damaging of the spindle or the tool positions if you
use improper tools
Improper tools can damage the collet chuck of the
spindle and / or the tool positions.
Only use tools with a sufficiently large chamfer at
the tool shank.
Install a retaining ring as a stop ring according to
DIN 471-A3.
Only insert tools with a maximum diameter of 3 mm
at the thickest part into the collet chuck.
Only insert tools with a maximum cutting edge
diameter of 2.6 mm into the tool magazine.
We recommend original tools as they are
designed especially for the designated jobs.
You can insert up to 16 tools into the tool magazine.
F . 20 – T
IG OOL MAGAZINE IN THE WORKING CHAMBER
( )
MARKED ORANGE
Normally, the machine loads tools from the tool
magazine of the machine. In the following cases, this
might not be possible:
A tool magazine position is worn so that it can no
n
longer properly hold a tool
You use tools which do not fit into the tool
n
magazine
In these cases, you can force a manual tool change in
PrograMill CNC (see the corresponding docu-
mentation).
If tool magazine inserts are worn, you should
replace them. (  Replacing the tool magazine
)
inserts – on page 33

Inserting and exchanging tools

You need to insert or exchange tools in the following
cases:
You can equip the tool magazine of your machine in
two ways:
Operating Instructions: PrograMill Dry Version: 2/19/2021
Upon first use of the machine
n
After exchanging tool magazine inserts due to
n
wear
When the tool life of a tool has expired
n
When tools are damaged or worn
n
If the next jobs require additional / different tools
n
than those in the tool magazine
You can check the remaining tool life of all
Tool management view
tools in the
PrograMill CNC.
By manually inserting the tools into the tool
n
magazine. This is the fastest way. It is described
below.
Via the spindle – you insert a tool into the collet
n
chuck and the spindle will deposit the tool in the
tool magazine. This option takes more time, but
might be more convenient for some. It is
described in the documentation for your
machine.
EN 23
in