10 Troubleshooting Guide - Ivoclar digital PrograMill Dry Instrucciones De Uso

EN 38

10 Troubleshooting guide

In case something is not working as intended, take a
look at the following troubleshooting guide.
NOTICE
Machine damage due to improper troubleshooting
In case of improper troubleshooting, your machine
may get damaged.
If you are unsure of how to perform certain steps
during troubleshooting or cannot solve the prob-
lems, abort the troubleshooting and contact your
authorized service partner.
Additional symbols in this chapter
Question to narrow down the problem
Suggested solution
I cannot open the working chamber door
Is the machine operating?
While the axes are moving, you cannot open the
working chamber door.
If applicable:
Wait until the machine has finished.
Has a power failure occurred at the installation site
of the machine?
If applicable:
Depending on the duration of the power failure,
restart the machine or perform an emergency open-
ing.
Is electricity available at the installation site of the
machine?
If applicable:
1. Connect the machine to the electrical source.
2. Switch on the machine at the main power switch.
3. If the working chamber lighting does not illu-
minate, check if the power cable is properly
seated in the machine and is connected to the
electrical source.
4. Try connecting the machine to a different socket.
Is the door blocked?
If applicable:
1. Switch on the machine at the main power switch.
2. If the working chamber lighting does not illu-
minate, check if the power cable is properly
seated in the machine and is connected to the
electrical source.
I have installed all components, started the
software but the machine does not reference
The machine does not reference with the working
chamber door open.
In this case a machine malfunction occurred.
My machine doesn't execute any jobs although
it is connected to the CNC computer
The machine does not reference with the working
chamber door open.
The machining results are not satisfactory and /
or tools keep breaking
sponding to the tools in the respective tool magazine?
If not, the machine uses the wrong tools during job
execution.
of the material holder contaminated by processing
dust?
Operating Instructions: PrograMill Dry Version: 2/19/2021
PrograMill Dry – Troubleshooting guide
3. If the machine is not powered, perform an emer-
gency opening when necessary.
Is the working chamber door open?
If applicable:
Close the working chamber door.
Is the working chamber illuminated in red?
If applicable:
1. Restart the machine.
2. If the working chamber continues to be illu-
minated in red, contact your service partner.
Is the working chamber door open?
If applicable:
Close the working chamber door.
Do the tool positions in the Tools section corre-
How to check this:
1. In PrograMill CNC, compare the tool positions in
the Tool management view with the tools in the
corresponding tool magazine.
2. Replace the wrong tools in the tool magazine with
the correct ones.
Is the material properly mounted?
How to check this:
Remove the material and remount it.
Are bolts, fixing mechanisms, gaps and openings
If applicable:
Clean the mentioned components thoroughly.