Troubleshooting The Stringhead - McCulloch MT3025 Manual Del Usuario

For Parts Call 606-678-9623 or 606-561-4983 For Parts Call 606-678-9623 or 606-561-4983
PROBLEME
Line won't feed.
Line snaps off or frays.
Unable to remove stringhead knob.
Stringhead and shaft are hot to the
touch.
19

10- TROUBLESHOOTING THE STRINGHEAD

CCAUSE PROBABLE
Line is tangled inside stringhead.
Upon removing spool, line appears to
be melted together.
Line wound in wrong direction inside
stringhead.
Insufficient line inside stringhead.
Internal damage to stringhead caused
by bumping too hard on ground while
advancing line.
Improper trimming procedures, or poor
quality line.
Stringhead knob overtightened.
Weed wrap.
www.mymowerparts.com www.mymowerparts.com
SOLUTION
Remove spool from unit; disassemble.
Untangle line and wind correctly in
direction indicated on spool (see Section
8-1).
Trim off damaged line and rewind line
(see Section 8-1).
Remove spool. Check to be certain line
is wound in direction indicated on line
element (see Section 8-1).
Remove spool and install new line (see
Section 8-1).
Disassemble stringhead and examine
parts for damage. Replace parts or
entire head (see Section 8-1).
See Trimming Procedures (see section
7-3) or replace line (see section 8-1)
Use anti-seize compound and reinstall
knob HAND TIGHT ONLY.
Remove weed wrap (see Section 7-2).