Safety Warnings; Purpose Of This Document; Additional Resources; Safety Symbols - Danfoss VLT OneGearDrive Serie Guia De Instalacion

Safety Warnings

1 Safety Warnings

1.1 Purpose of this Document

The purpose of this document is to describe the instal-
®
lation of the VLT OneGearDrive.
®
The VLT OneGearDrive is available with 2 different motor
types:
•
LA10 (type code L09), relegated to service only
since August 2015.
•
V210 (type code L06), since August 2015.
Check the motor type on the nameplate.
NOTICE
If exchanging a OneGearDrive with LA10 motor type
with a V210 motor type, always ensure to update the
®
motor model in the VLT AutomationDrive FC 302.
Contact Danfoss Service for further instructions.
NOTICE
For reasons of clarity, the instructions and safety
information do not contain all information relating to all
OneGearDrive types and cannot take into account every
conceivable case of installation, operation, or
maintenance. The information is limited to that which is
required for qualified personnel in normal working
situations. Contact Danfoss for further assistance.
Compliance with the information in this document is a
prerequisite for:
•
Trouble-free operation.
•
Recognition of product liability claims.
Therefore, read this document before working on or with
the OneGearDrive.
®
VLT is a registered trademark.

1.2 Additional Resources

®
The full VLT OneGearDrive Operating Guide is available
online at drives.danfoss.com/knowledge-center/technical-
documentation/.
Document Contents
® Information about the installation,
VLT OneGearDrive
commissioning, and operation of the
Operating Guide
®
VLT OneGearDrive.
®
Table 1.1 VLT OneGearDrive Operating Guide
M0021001

1.3 Safety Symbols

The following symbols are used in this guide:
WARNING
Indicates a potentially hazardous situation that could
result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation that could
result in minor or moderate injury. It can also be used to
alert against unsafe practices.
NOTICE
Indicates important information, including situations that
can result in damage to equipment or property.

1.4 Intended Use

®
The VLT OneGearDrive is intended for commercial instal-
lations, unless otherwise expressly agreed. It complies with
the standards of the series EN 60034/DIN VDE 0530. Use in
a potentially explosive atmosphere is forbidden, if not
expressly intended for this purpose. Increased safety
precautions (for example protection against access by
children's fingers) are required in special cases, such as use
in non-commercial installations. Ensure these safety
conditions when setting up the installation. The
OneGearDrive is designed for ambient temperatures
between -20 °C (68 °F) to 40 °C (104 °F) and for instal-
lation heights up to 1000 m (3280 ft) above sea level. Any
deviations found on the nameplate must be considered.
Ensure that the conditions at the place of work correspond
to all the nameplate data.
CAUTION
Low-voltage machines are components for installation in
machines in the sense of the machinery directive
2006/42/EC.
•
Do not use the machine until conformity of the
final product with this directive is established
(refer to EN 60204-01).

1.5 Qualified Personnel

All necessary work on electric drive units must only be
performed by adequately qualified personnel (for example
electrical engineers as specified in draft EN 50110-1/DIN
VDE 0105). The operating guide and other product
documentation must be available during any
Danfoss A/S © 07/2017 All rights reserved.
1 1
3