High Altitude Operation - Home Depot 0H9681 El Manual Del Propietario

Figure 1.2 — Turn Latch
2. Remove the two side panels of the enclosure by lifting the
panels straight up until they are clear (Figure 1.3).
Figure 1.3 — Remove Side Panels
3. Carefully place the roof and side panels to one side.
4. Locate the fuel throttle assembly mounted to the engine
intake.
5. To change the fuel selection, remove the hose clamp and hose
from the throttle assembly (Figure 1.4).
Figure 1.4 — Remove Hose Clamp & Hose
Remove Clamp
and Hose
6. Remove the Natural Gas (Larger ID) fuel jet from the fuel inlet
(Figure 1.5).
7. Obtain the fuel jet for Propane (Smaller ID that has been sup-
plied loose with the owners manual).
8.
Verify that the O-ring, supplied loose with the owners manual
is installed, into the groove of the fuel jet.
9. Insert the Propane fuel jet into the end of the fuel inlet.
10. Reinstall the hose and clamp onto the fuel inlet and secure.
11. Verify the hose has not been kinked in any way.
12. The generator is now ready to run on LP Vapor fuel.
Figure 1.5 — Remove Fuel Jet
Throttle
Assembly
Fuel Jet

1.11 HIGH ALTITUDE OPERATION

The fuel system on this generator may be influenced by operation
at higher altitudes. Proper operation can be ensured by installing
an altitude kit when required. See the table below to determine
when an altitude kit is required. Operating this generator without
the proper altitude kit installed may increase the engine's emis-
sions and decrease fuel economy and performance. Kits may be
obtained from any Dealer, and should be installed by a qualified
individual.
Unit Fuel Altitude Range*
LP Vapor
6/7 kW
Nat. Gas
2000 - 6500 ft**
" Elevation above sea level
** At elevations above 6500 ft. the engine may experience
decreased performance.
General Information
Fuel Inlet
O-Ring (installed)
Hose Clamp
Regulator
Hose
Kit Part Number
0- 6500 ft** Not Required
0- 2000 ft Not Required
OJ7057
7