Electrical Installation; Installing The Microwave - Zanussi ZSG20100 Manual De Instrucciones

CAUTION! Do not connect the
appliance to adapters or extension
leads. This can cause overloading and
risk of fire.
CAUTION! The minimum installation
height is 85 cm.
• The microwave is for built-in use only. It must be
placed on a stable and flat surface.
• The cabinet can not have a back wall in the
place where the microwave is located.
• Put the microwave far away from steam, hot air
and water splashes.
• If the microwave is to close to the TV and radio
it may cause interference in the received signal.
• If you transport the microwave in cold weather,
do not activate it immediately after the
installation. Let is stand in the room temperature
and absorb the heat.

ELECTRICAL INSTALLATION

WARNING! Only a qualified person
must do the electrical installation.
The manufacturer is not responsible if
you do not follow the safety
precautions from the chapter "Safety
Information".
This microwave is supplied with a main cable and
main plug.
The cable has an earth wire with an earthing plug.
The plug must be plugged into an outlet that is
properly installed and earthed. In the event of an
electrical short circuit, earthing reduces the risk of
electric shock.

INSTALLING THE MICROWAVE

1. Check if the dimensions of the furniture meet
the installation distances.
C
D
A
B
Installation distances
Dimension
A
B
C
D
2. If the cabinet depth is over 300 mm, put the
template on the bottom of cabinet and check if
it fits. If yes, mark the spots for screws. Remove
the template and fix the bracket with the
screws in the marked spot.
Skip this step if the cabinet depth
is 300 mm.
3. Install the microwave. If you fixed the bracket,
make sure it locks the back of the appliance.
mm
380 + 2
560 + 8
340
18
=
=
25