Before First Use - Silvercrest SDBR 420 A2 Instrucciones De Uso

Before first use
1) Remove the iron from the packaging.
RISK OF SUFFOCATION!
► Plastic bags may pose a risk. To avoid the risk of asphyxiation,
keep plastic bags out of the reach of toddlers and small children.
2) Open the water tank filler opening 1 and fill the water tank with
water (See the section Filling the water tank).
3) Set the correct voltage using the voltage switch 7. You can, for
example, use a thin pin or a straightened paper clip to do this.
Slide the voltage switch 7 to the right to set a voltage of
―
220 – 240 V (e.g. for Europe/Switzerland).
Slide the voltage switch 7 to the left to set a voltage of
―
100 – 127 V (e.g. for USA/Japan).
4) Insert the plug into a mains power socket supplying the voltage
you have set.
5) Set the temperature control 4 to "MAX"
6) Heat the iron up for several minutes at the highest setting.
7) If clicked in: press the steam switch
and protrudes beyond the appliance surface. Steam will
come out of the sole of the iron 8 continuously if you hold
the iron horizontally.
8) Then iron over a piece of scrap fabric to remove any production
residues that may remain on the ironing sole 8.
9) Press the steam switch
The steam discharge then stops.
│ GB │ IE
■ 10
.
3 so that it releases
3 again so that it re-engages.
SDBR 420 A2