Warning Symbol Identification; Servicing The Tool - Ingersoll Rand 1103 Manual De Instrucciones

Note the position of the reversing lever before
•
operating the tool so as to be aware of the direction
of rotation when operating the throttle.
Use only impact sockets and accessories. Do not
•
use hand (chrome) sockets or accessories.
The use of other than genuine Ingersoll- - Rand replacement parts may result in safety hazards, decreased tool
performance, and increased maintenance, and may invalidate all warranties.
Repairs should be made only by authorized trained personnel. Consult your nearest Ingersoll- - Rand Authorized
Servicenter.
WARNING
Always wear eye protection
when operating or
performing maintenance
on this tool.
Lubrication
Ingersoll- - Rand No. 10
(Oil)
Always use an air line lubricator with these tools.
We recommend the following Filter- - Lubricator- - Regulator
Unit:
For USA use Unit Number C28- - 04- - FKG0- - 28
For International use Unit Number C28- - C4- - FKG0
Before starting the tool and after each two or three
hours of operation, unless the air line lubricator is used,
pour approximately 1.5 cc of Ingersoll- - Rand No. 10 Oil
into the air inlet.
Periodically, inject several drops of Ingersoll- - Rand
No. 10 Oil between the Ratchet Housing (39) and Ratchet
Yoke (37) to lubricate the Drive Bushing (36).
Free
Speed
Model Model Drive Drive
rpm
1103 1/4" 270
1133 3/8" 270
Tested in accordance with PNEUROP PN8NTC1.2
H
♦ Tested in accordance with ISO8662- - 1
Using the Tool (Continued)
CAUTION NOTICE

WARNING SYMBOL IDENTIFICATION

Read this manual before
operating tool.

SERVICING THE TOOL

Ingersoll- - Rand No. 28
For the Gearing
and
For the Ratchet Housing
Ingersoll- - Rand No. 66
(Grease)
SPECIFICATIONS
Recommended
HSound Level
Torque
Range
ft- - lbs (Nm) Pressure
5- - 23 (7- - 31) 89
5- - 25 (7- - 34) 89
2
Whenever the Ratchet Head is installed or
•
repositioned, the Throttle Lever must be positioned
so that reaction torque will not tend to retain the
throttle in the "ON" position.
Ratchet Wrenches are not torque wrenches.
•
Connections requiring specific torque must be
checked with a torque meter after fitting with an
impact wrench.
WARNING
Installation
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
FILTER
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
♦Vibrations
dB (A) Level
2
Power m/s
102 4.6
102 4.6
WARNING
Always wear hearing
protection when operating
this tool.
COMPRESSOR
(Dwg. TPD905- -1)
Inlet Minimum
Connec- Inside Ø
tion Air Hose
Thread Inches
Type (mm)
1/4" NPT 1/4 (6.35)
1/4" NPT 1/4 (6.35)