Warning Symbol Identification; Placing Tool In Service - Ingersoll Rand 252 Manual De Instrucciones

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
SETTING THE POWER REGULATOR
Impact wrenches are not torque control devices.
Fasteners with specific torque requirements must be
checked with suitable torque measuring devices after
installation with an impact wrench.
252, 252- - EU, 252- - 3- - EU Impact Wrench incorporates a
power regulator into the reverse mechanism.
LUBRICATION
Ingersoll- - Rand No. 50
Always use of an air line lubricator with these tools.
We recommend the following Filter- - Lubricator- - Regulator
Unit:
For International- - No. C28- - C4- - FKG0
For U.S.A. - - No. C28- - 04- - FKG0- - 28
After each eight hours of operation, unless an air line
lubricator is used, detach the air hose and inject about
1- - 1/2 cc of oil into the Inlet Bushing (52).
Model Type of
Handle
252, 252- - EU pistol
252- - 3- - EU pistol
Tested in accordance with PNEUROP PN8NTC1.2
H
♦ Tested to ISO8662- - 1 loaded with frictionbrake to 9 RPM

WARNING SYMBOL IDENTIFICATION

Always wear hearing
protection when operating
this tool.
Do not carry the tool by the
hose.
90 psig
Operate at 90 psig (6.2 bar/
(6.2bar/620kPa)
620 kPa) Maximum air pres-
sure.
ADJUSTMENTS

PLACING TOOL IN SERVICE

SPECIFICATIONS
Drive Impacts
per min.
in.
3/4" sq. 1100
3/4" sq. 1100
WARNING
WARNING
WARNING
International Warning Label:
Order Part No. ___________
To adjust the power, rotate the Power Regulator (9) until
the notch aligns with the number of the desired power
setting.
The numbers 1 thru 3 on the housing are only for
reference and DO NOT denote a specific power output.
One (1) designates the lowest power output while three
(3) denotes the highest.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
FILTER
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
Recommended HSound Level
Torque Range
ft- - lbs (Nm) Pressure
100- - 500 92.7
(135.6- - 678)
100- - 500 92.7
(135.6- - 678)
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
COMPRESSOR
(Dwg. TPD905- -1)
♦Vibrations
dB (A) Level
2
Power m/s
105.7 3.0
105.7 3.0