Dc Voltage Measurement; Measure Frequency - koban KPA 02 Manual Del Usuario

KPA 02
Digital clamp meter

DC Voltage Measurement

Warning
Electric shock hazard.
Pay special attention to avoid shock when measuring high voltage.
Don't input voltage more than DC1000V .
• Insert the black probe into COM jack and red probe into INPUT jack.
• Place transfer switch to AC voltage V
voltage measurement state.
• Connect the probe with voltage source or both ends of load in parallel for
measurement.
• LCD will show readings. Polarity indication shows the load connected with
the red probe.
Note:
1. In the small voltage measuring range, the probe is not connected with the
circuit to be tested, and the meter may have fluctuating readings, which
is normal and caused by the meter's high sensitivity. When the meter
is connected with the circuit to be tested, you will get actual measured
value.
2. In the manual measuring range mode, the LCD only shows "OL" or
"-OL", which indicates overrange. Choose a higher measuring range.
3. means that maximum input voltage is 1000V AC.

Measure frequency

Warning
Electric shock hazard.
Pay special attention to avoid shock when measuring high voltage. Don't
input voltage more than AC 250V RMS.
• Insert black probe to the COM jack and insert red probe to the INPUT jack.
• Place transfer switch in position HZ.
• Connect the probe with signal or both ends of load in parallel for
measurement.
• LCD will show readings
Instructions manual | 32
position. Press FUNC to select DC
www.grupotemper.com