Dc & Ac Voltage Measurement; Resistance Measurement; Diode Measurement - koban KPA-20 Manual De Instrucciones

make measurements
conductors are clamped at the same time.
4. Display reading is flow the conductor AC current.
DC & AC VOLTAGE MEASUREMENT
1. Connect red test lead to "V" jack, Black lead to
"COM" jack.
2. Set RANGE switch to desired VOLTAGE position,
if the voltage to be measured is not known
beforehand, set switch to the highest range and
reduce it until satisfactory reading is obtained.
3. Connect test leads to device or circuit being
measured.
4. Turn on power of the device or circuit being
measured voltage value will appear on Digital
Display along with the voltage polarity.

RESISTANCE MEASUREMENT

1. Red lead to "Ω". Black lead to "COM".
2. RANGE switch to desired Ω position.
3. If the resistance being measured is connected to
a circuit, turn off power and discharge all
capacitors before measurement.
4. Connect test leads to circuit being measured.
5. Read resistance value on Digital Display.

DIODE MEASUREMENT

1. Red lead to "Ω", Black lead to "COM".
2. RANGE switch to "
3. Connect the red test lead to the anode of the
diode to be measured and black test lead to
cathode.
when
" position.
- 37 -
two or three