Preparations At The Workplace; Fitting The Depth Gauge; Changing The Bit In The Sd 2500 - Hilti ST 2500 Manual De Instrucciones Original

5 Operation

5.1 Preparations at the workplace

CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making adjustments to the power tool or before changing
accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1.1 Removing the protective sleeve
▶ Insert the tip of a screwdriver between the protective sleeve and the power tool.

5.1.2 Fitting the depth gauge

WARNING
Electrical hazards There is a risk of electric shock if a screw is driven into a concealed electric cable
and, at the same time, the bit holder or depth gauge is touched.
▶ Hold the screwdriver only by the grip when driving or removing screws.
Note
When driving screws with a sealing washer, use a depth gauge suitable for the diameter of the sealing
washer (accessory). When the depth gauge is correctly adjusted the screw seal will be correctly
compressed.
The depth gauge is attached to the metal-construction screwdriver by a snap connection and can be
simply pulled off or pushed on.
▶ Fit the depth gauge.
5.1.3 Removing the depth gauge
CAUTION
Risk of injury The depth gauge may hinder the operator if fitted but not used.
▶ Remove the depth gauge from the tool.
▶ Pull the depth gauge forward, away from the power tool.
5.1.4 Adjusting the depth gauge of the SD 2500
Note
Turn the depth gauge clockwise to reduce the depth to which the screws are driven.
Turn the depth gauge counter-clockwise to increase the depth to which the screws are driven.
▶ Adjust the depth gauge.

5.1.5 Changing the bit in the SD 2500

CAUTION
Risk of injury. The accessory tool may be hot or have sharp edges.
▶ Wear protective gloves when using the power tool and when changing accessory tools.
▶ Change the bit.
14 English
Printed: 09.11.2016 | Doc-Nr: PUB / 5070743 / 000 / 03
2
5
4