Setting The Safety Level; Setting The Relay Switching Time For The Inside Unit (Only With On-Wall/In-Wall Version) - G-U BKS Manual De Instrucciones

Operating instructions
Fingerprint scanner and code keypad

3.6 Setting the safety level

3.7 Setting the relay switching time for the inside unit (only with on-wall/in-
wall version)

Press the RT button

Enter the digit(s) for the relay switching time in seconds (1 to 60 seconds)

Press the OK button to acknowledge

In the delivery condition the switching time of both relays is set to 5 seconds.
Operating instructions, edition 3 dated 03/01/2013
Copyright © G-U GmbH, 2012. All rights reserved.
The device is then in the delivery condition (red
+ green + blue LEDs light up)
Master
Drag a master finger across the sensor, the red
finger
and green LEDs light up briefly.
Press button H or M or L and confirm with OK
button





Button L: low security (corresponds to 3-
digit PIN code security)
Button M: medium security (corresponds to
4-digit PIN code security)
Button H: high security (corresponds to 5-
digit PIN code security)
The red and green LEDs light up briefly
twice to acknowledge that the setting has
been applied
The medium safety level M is preset in the
delivery condition. The safety level can be
reconfigured at any time.
Page 43
C 59 501 106