Protecting The Cooktop - Kenmore 911.95281 Manual De Uso

® OPERATION
Protecting the Cooktop
o DO NOT slide cookware across
your cooktop.
,, DO NOT use scouring powders
or metal cleaning pads on your
cooktop.
o DO NOT apply your cooktop
cleaning creme to the cooktop
surface if the surface is hot.
÷
o READ the instruction label on the
cooktop cleaning creme bottle
before attempting to clean the
surface of your cooktop.
_,AFTER cleaning the cooktop
surface, be sure to wipe off any
residue that may be left from the
creme with a dry paper towel.
o FOR MAJOR spills, turn the
surface control knob to OFR Use
a dry paper towel to wipe up spill,
then use a razor scraper (held with
a potholder) at a 30 ° angle against
the surface of the cooktop to
scrape remaining spill from the
hot cooking zone.
30 ° angle
f' CAUTION: When the _
surface controls are
turned off, the Hot
Surface Indicator light
will remain lit until the cooktop
surface has cooled to
approximately 150°F. The glass-
ceramic surface will retain heat
after the indicator light goes
out. Use caution until the
cooktop surface has had time
,p oo,: j
To remove the adhesive left from
packaging tape, use household
dishwashing liquid, minera! oil or
cooking oil. With a soft cloth rub into
the area and allow to soak. Rinse
and dry well. Repeat procedure
using an appliance polish to insure
no damage is done. This should be
done before the range is turned on
for the first time. The tape cannot
be removed once the range has
heated. Packaging tape may be
found in the following areas: Cooktop
surface, Door Handle, Control Panel
area, Door Trim and Oven area.
o DO NOT cook directly on the
surface of the glass.
,, DO NOT use the cooktop as
a cutting board.
7