Tabla de contenido
Idiomas disponibles
Idiomas disponibles
en
en
18 | EL–52425 | Product description
CAUTION – Risk of injury from objects
falling off the EL–52425.
¶
Fasten the calibration board and P-Assist
laser unit with securing cables when
working.
¶
For assembly, disassembly and trans-
port, remove the calibration board and
the laser unit.
WARNING – Severe eye damage from
laser beam.
¶
Never look directly into the laser source.
¶
Never point the laser beam at people,
particularly at their face or eyes.
¶
To test function, hold an object in front
of the laser exit point.
3.
Product description
3.1
Intended use
The EL–52425 is intended only for static calibration of
sensors and cameras on motor vehicles. The repair and
service instructions specific to the vehicle manufactu-
rer are authoritative. Any other or additional application
does not constitute intended use.
3.2
Measurement bay prerequisite
Evenness of measurement bay
R
The vehicle must be standing on a flat surface.
R
The levelness of the floor must not vary by more
than ±7 mm/m.
This corresponds to 0.4 degrees.
Test bay conditions
R
The vehicle must be empty.
R
The vehicle's tires must be inflated to the specified
tire inflation pressure.
R
The calibration board must stand on the same flat
floor as the vehicle.
R
The calibration board must be clean and free of mar-
kings, discoloration or other blemishes.
R
Perform the calibration under normal lighting condi-
tions:
$
Daylight, fluorescent light, conventional LED
light.
$
There must be no bright light source in the field
of view of the CCD camera.
|
1 690 386 081
2018-02-22
3.3
Scope of delivery / Special accesso-
ries
Designation
Base plate with assembly material
Post with slide
Original operating instructions
Tape measure
Chalk line
Plumb bob
Precision holder with mount
Tape measure holder
Universal target, Type 1
Protective hood
Universal target, Type 3
1)
–
Position indicator (EL
51747-2)
Laser unit
1)
Securing cable
1)
Setting aid
1)
Special accessory
1)
For universal target, Type 3
2)
3.4
EL–52425
1
2
6
3
4
5
Fig. 1:
EL–52425
1 Mount for precision holder
2 Calibration board
3 Post
4 Tape measure holder
5 Wheeled base plate
6 Precision holder
Part number
1 690 381 263
1 690 381 254
1 690 386 081
1 693 740 533
1 693 740 815
1 693 740 685
1 690 381 261
1 690 382 499
1 690 382 288
1 690 382 497
1 690 382 485
1 690 382 583
1) 2)
1 690 381 124
1 690 381 237
1 690 381 210
Robert Bosch GmbH
Capítulos
Tabla de contenido
