Electrical Requirements; Installation Instructions; Remove Transport System - Maytag MHN33PDCWW Instrucciones De Instalación

Floor drain system
The floor drain system requires a siphon break that may be
purchased separately. See "Tools and Parts. "
The siphon break must be a minimum of 28" (710 mm) from
the bottom of the washer. Additional hoses might be needed.
28" min.
(710 mm)

Electrical Requirements

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
A 120 V, 60 Hz, AC only, 15 A or 20 A, fused electrical supply
■
is required. A time-delay fuse or circuit breaker is recommended.
It is recommended that a separate circuit serving only this
washer be provided.
This washer is equipped with a power supply cord having
■
a 3 prong grounding plug.
To minimize possible shock hazard, the cord must be plugged
■
into a mating, 3 prong, grounding-type outlet, grounded in
accordance with local codes and ordinances. If a mating outlet
is not available, it is the personal responsibility and obligation of
the customer to have the properly grounded outlet installed by a
qualified electrician.
If codes permit and a separate ground wire is used, it is ■
recommended that a qualified electrician determine that
the ground path is adequate.
Do not ground to a gas pipe.
■
Check with a qualified electrician if you are not sure
■
if the washer is properly grounded.
Do not have a fuse in the neutral or ground circuit.
■
6
INSTALLATION
INSTRUCTIONS

Remove Transport System

WARNING
Excessive Weight Hazard
Use two or more people to move and install washer.
Failure to do so can result in back or other injury.
IMPORTANT: Position the washer so that the rear of the washer is
within approximately 3 ft. (900 mm) of its final location.
There are four shipping bolts in the rear panel of the washer that
support the suspension system during transportation. These bolts
also retain the power cord inside the washer until the bolts are
removed.
1. Keep the washer in the upright position while removing
the shipping bolts.
Shipping bolt
Shipping bolt
Shipping bolt with plastic spacer