Electrical Requirements; Earthing Instructions - Maytag MAT20PDFGW Instrucciones

Connect Inlet Hoses to Washer
1. Attach cold water hose to cold water inlet valve marked
with a blue ring. Screw coupling by hand until it is snug.
2. Attach hot water hose to hot water inlet valve marked
with a red ring. Screw coupling by hand until it is snug.
3. Use pliers to tighten couplings an additional two-thirds turn.
NOTE: Do not overtighten. Damage to the valve can result.
4. Turn on water faucets to check for leaks. A small amount of
water may enter washer. It will drain later.
NOTE: Replace inlet hoses after five years of use to reduce the
risk of hose failure. Record hose installation or replacement
dates on the hoses for future reference.
Periodically inspect and replace hoses if bulges, kinks, cuts,
wear, or leaks are found.

ELECTRICAL REQUIREMENTS

WARNING
Electrical Shock Hazard
Electrically ground this appliance.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
n A 220 V–240 V, 50 Hz AC only, 10 A, fused electric supply is
required. A time-delay fuse or circuit breaker is recommended.
It is recommended that a separate circuit serving only this
appliance be provided.
n After installation, access to mains plug must be ensured at all
times in order to ensure immediate deactivation of the washer
in case of emergency.
n This washer is provided with an appliance inlet intended to
be attached to a power supply cord. The plug should be
accessible for disconnection from the supply. Available power
cord part numbers listed in Alternate Parts & Accessories
Section.
n The appliance inlet, power supply cord, and retainer bracket
must remain fully assembled and connected. If any component
becomes damaged and/or disconnected, the appliance must
be unplugged and the damaged component must be replaced
by the manufacturer, its service agent, or similarly qualified
persons in order to avoid a hazard.
IMPORTANT: Washer installation and service must be performed
by a Maytag authorized service person.

EARTHING INSTRUCTIONS

This washer must be earthed. In the event of a malfunction
or breakdown, earthing will reduce the risk of electric
shock by providing a path of least resistance for electric
current. This washer is equipped with a cord having an
equipment-earthing conductor and an earthing plug. The
plug must be plugged into an appropriate outlet that is
properly installed and earthed in accordance with all local
codes and ordinances.
WARNING:
Improper connection of the equipment-
earthing conductor can result in a risk of electric shock.
Check with a qualified electrician or serviceman if you are in
doubt as to whether the appliance is properly earthed.
Do not modify the plug provided with the appliance – if it will
not fit the outlet, have a proper outlet installed by a qualified
electrician.
13