Location Requirements
Selecting the proper location for your washer improves performance
and minimizes noise and possible washer "walk. "
Your washer can be installed under a custom counter, or in a
basement, laundry room, or recessed area. See "Drain System. "
Companion appliance location requirements should also be
considered. Proper installation is your responsibility.
You will need
A water heater set to deliver 120°F (49°C) water to the washer.
■
A grounded electrical outlet located within 6 ft. (1.8 m) of where
■
the power cord is attached to the back of the washer. See
"Electrical Requirements."
Hot and cold water taps located within 4 ft. (1.2 m) of
■
the hot and cold water fill valves, and water pressure of
20 psi–100 psi (137.9 kPa–689.6 kPa).
A level floor with a maximum slope of 1" (25 mm) under entire
■
washer. Installing the washer on soft floor surfaces, such as
carpets or surfaces with foam backing, is not recommended.
A sturdy and solid floor to support the washer with a total weight
■
(water and load) of 400 lbs (180 kg).
Do not operate your washer in temperatures below 32°F (0°C).
Some water can remain in the washer and can cause damage
in low temperatures.
Installation clearances
The location must be large enough to allow the washer door to be
■
fully opened.
Additional spacing should be considered for ease of installation
■
and servicing. The door opens more than 90°, and it is not
reversible.
Additional clearances might be required for wall, door, and floor
■
moldings.
Additional spacing of 1" (25 mm) on all sides of the washer is
■
recommended to reduce noise transfer.
Companion appliance spacing should also be considered.
■
Washer Dimensions
1
50
/
"
2
(1282 mm)
Door is not reversible
27"
(686 mm)
5
44
/
8
(1134 mm)
13
37
/
"
16
(961 mm)
13
28
"
/
16
(732 mm)
A floor drain should be provided under the bulkhead. Prefabricated
bulkheads with electrical outlets, water inlet lines, and drain facilities
should be used only where local codes permit.
The washer can be installed using the standpipe drain system
(floor or wall), the laundry tub drain system, or the floor drain system.
Select the drain hose installation method you need.
See "Tools and Parts. "
Standpipe drain system – wall or floor (views A & B)
The standpipe drain requires a minimum diameter standpipe
of 2" (50 mm). The minimum carry-away capacity can be no
less than 10 gal. (38 L) per minute, per washer.
The top of the standpipe must be at least 30" (762 mm) high
and no higher than 96" (2.4 m) from the bottom of the washer.
Laundry tub drain system
The laundry tub needs a minimum 20 gal. (76 L) capacity. The top
of the laundry tub must be at least 30" (762 mm) above the floor.
"
Drain System
30" min.
(762 mm)
A
B
30" min.
(762 mm)
28" min.
(710 mm)
5