Belly Height Installation (Countries Other Than The U; Determine Pet Door Location; Prepare Wall - Petsafe MPA19-13800 Manual De Instalación

Belly Height Installation
SteP 2
(CoUntrIeS otHer tHAn tHe U.S.A.)

Determine Pet Door location

2A.
Locate the wall studs in selected installation area. Locate the center
between the studs. Using a pencil, draw a level vertical line on wall
through the center.
2B.
Measure and mark your pet's belly
height on the vertical line. Draw a
level horizontal line through the belly
height line.
Check for electrical and plumbing fixtures that could be inside the wall where you wish to install
the pet door. If utilities are in the wall, additional preparation will be required to re-route or
relocate these utilities or a different installation location should be selected. Review exterior wall
area of chosen location for pet traffic obstacles or features which could prevent the pet door
installation, such as utilities and landscaping features.
If unable to install pet door between studs, the cutting of a stud may be required for the wall kit to
fit properly. A support above the cut stud should be installed to maintain wall integrity.
SteP 3
(CoUntrIeS otHer tHAn tHe U.S.A.)

Prepare Wall

3A.
Using the cutting template supplied with your Passport
with the marked lines on wall. Tape template into place.
3B.
Check that the template is square. Adjust as needed.
3C. Trace template with a pencil. Carefully remove template to reuse for exterior wall cut-out. Review
cut-out location on both interior and exterior to ensure it is the best possible location for the
pet door.
3A
(Countries other than the U.S.A.)
2B
Belly Height
door/flap, match the lines on the cutting template
™
3B
www.petsafe.net
2A
Wall
Studs
3C
9