Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Hereinafter Radio Systems Corporation, Radio Systems PetSafe Europe Ltd., Radio Systems Australia Pty Ltd. and any other
affiliate or Brand of Radio Systems Corporation may be referred to collectively as "We" or "Us".
IMPORTANT SAFETY INFORMATION
Explanation of Attention Words and Symbols used in this guide
WARNING, indicates a hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION, used without the safety alert symbol, indicates a hazardous situation which, if not avoided,
could result in harm to your pet.
NOTICE, is used to address safe use practices not related to personal injury.
The Fox Den Toy is not a child's toy. This product is intended for cats- not for children or dogs. Do not
allow unsupervised use while in the presence of children.
Do not use the Fox Den Toy until you have read the entire Operating Guide.
Do not use the Fox Den Toy on an elevated surface such as a table or counter. Use on the floor only.
This product should only be used in accordance with the instructions in the Operating Guide.
Do not use rechargeable batteries. If rechargeable batteries are used, they must be removed from the toy
prior to recharging, and must only be charged under adult supervision.
Non-rechargeable batteries are not to be recharged
Batteries are to be inserted with correct polarity
The supply terminals are not to be short-circuited
Adult supervision is required around cats. Do not allow unattended "Play-All-Day" Mode until you know
your cat uses the toy as intended.
Tail could become a choking hazard if chewed.
Do not mix old and new batteries or different types of batteries. When batteries are stored or disposed,
they must be protected from shorting. Dispose of used batteries properly.
These instructions must be retained and passed on with ownership.
Toy Assembly
No assembly is required. Simply install batteries, press power button and place the Fox Den Toy Automatic Cat Teaser on the floor
to use. Do not place the toy on any surface other than a flat, level floor.
Battery Installation
1.
Remove the battery door which is located on the bottom of the toy (A).
2.
Insert 3, AA batteries into the battery compartment (B).
3.
Replace the battery door and ensure it is closed properly.
4.
Press power button on side of toy to turn on (C).
2
petsafe.com
Operating Instructions
One-Time-Play Mode
Press and release the power button located on the side of the toy to turn on.
• The toy will automatically turn off after 10 minutes.
• Press and release the power button if you wish to end a play session before the toy automatically turns off.
"Play-All-Day" Mode
Observe your cat playing with the toy before you enable the "Play-All-Day" mode. Make sure your cat
can safely play with the toy in this mode, and that the toy is working properly before leaving your cat alone.
• To activate multiple play sessions throughout the day: When the toy is off, press and hold the power button for 3 seconds until
the toy beeps 3 times. The audible beeps indicate the toy will cycle through 3 play sessions.
• The next play session will begin 2 hours after the first play session. The final play session will begin 2 hours after the second
play session has finished. The motion sensor will remain on during rest time.
• Each play session will last 10 minutes.
• During rest time, the toy will turn on for 2 minutes if motion is detected within 0.9-1.2 metres in front of the toy, where the tail appears.
• The toy will rest again within 2 minutes once the cat walks away. NOTE: There is a delay of 25 seconds after the 2 minutes of
play before more motion is detected.
• Press the power button quickly, then release to turn the toy off.
• Ensure the toy is in a safe location for your cat to play each time the "Play-All-Day" Mode is activated and prior to leaving
your cat unsupervised with the toy.
• The "Play-All-Day" Mode should be used at the owner's discretion.
Advice for use
Apart from playing with this product, it is recommended that pet parents interact with their pets and provide a variety of play
activities, opportunities for stimulation, and an appropriate amount of daily exercise as determined by their veterinarian.
Important Recycling Advice
Please respect the Waste Electrical and Electronic Equipment regulations in your country. This equipment must be recycled.
If you no longer require this equipment, do not place it in the normal municipal waste system. Please return it to where it was
purchased in order that it can be placed in our recycling system. If this is not possible, please contact the Customer Care Centre
for further information. For a listing of Customer Care Centre telephone numbers, visit our website at petsafe.com.
Compliance
Radio Systems Corporation declares under its own responsibility, that the following product is in compliance with the essential
requirements under the EMC Directive 2014/30/EU, and the RoHS 2 Directive (EU) 2015/863. Unauthorised changes or
modifications to Corporation may violate EU EMC regulations, could void the user's authority to operate the equipment, and will
void the warranty.Hereby, Radio Systems Corporation, declares that this product is in compliance with the essential requirements and
other relevant provisions. The Declaration of Conformity can be found at: http://www.petsafe.com/customercare/eu_docs.php.
IC
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
petsafe.com
3
Tabla de contenido
