Shoulder Height Installation (U.s.a. Only); Determine Pet Door Location; Prepare Wall - Petsafe MPA19-13800 Manual De Instalación

Shoulder Height Installation
SteP 2
(U.S.A. only)

Determine Pet Door location

2A.
Locate the wall studs in selected installation area.
Locate the center between the studs. Using a pencil,
draw a level vertical line on wall through the center.
2B.
Measure and mark your pet's shoulder height on the
vertical line. Draw a level horizontal line through the
shoulder height line.
Check for electrical and plumbing fixtures that could be inside the wall where you wish to install
the pet door. If utilities are in the wall, additional preparation will be required to re-route or
relocate these utilities or a different installation location should be selected. Review exterior wall
area of chosen location for pet traffic obstacles or features which could prevent the pet door
installation, such as utilities and landscaping features.
If unable to install pet door between studs, the cutting of a stud may be required for the wall kit to
fit properly. A support above the cut stud should be installed to maintain wall integrity.
SteP 3
(U.S.A. only)

Prepare Wall

3A.
Using the cutting template supplied with your Passport
center and shoulder height lines with the marked lines on wall. Tape
template into place.
3B.
Check that the template is square. Adjust as needed.
3C.
Trace template with a pencil. Carefully remove template to reuse for
exterior wall cut-out. Review cut-out location on both interior and
exterior to ensure it is the best possible location for the pet door.
Proceed to Step 4 on page 10.
8
(U.S.A. only)
door, match the
™
www.petsafe.net
2A
Center Between
Studs
2B
Shoulder
Height
3A
Shoulder Height
3B
3C